Average Reviews:
(More customer reviews)These screen guards arrived undamaged in a flat, business sized envelope. When I opened the package for them, the three guards were sandwiched between the two layers of the cardboard labeling. The microfiber cleaning cloth was there also. However, contrary to the instructions on the package label, my package did not contain the squeegee for removing the bubbles. That was not a problem, as I used as a substitute one of the key-ring tabs for a store affinity program, which worked just as well.
1st attempt:
1st issue: It should be labeled clearly which side of the protector is the adhesive side which should be applied to the screen. Both sides had a protective cover, which was good. One tab was labeled 1 and the other as 2. Both said to remove before applying. I first had to figure out which was the non-sticky side since nothing on the label indicated which was which.
2nd issue: Unless one has very small fingers, it is difficult to use the tiny cloth to wipe the screen without touching it.
3rd issue: As others have said, the alignment of the guard with the screen is tricky. Getting it in place while peeling the protective layer is finicky work. My first attempt wound up having dust under it, making a couple of bubbles that could not be removed. Also, by removing the outer layer of protective plastic, it made it difficult to avoid scratching the plastic of the guard. After several attempts to reposition the first guard, and unable to avoid touching the underside while attempting to remove the dust spots, I removed it so I could try again with a new one.
2nd attempt:
Using the lessons I learned with the first one, I did not remove the plastic protecting the outside surface. I re-cleaned the screen and carefully positioned the second one, peeling the protective layer for the adhesive side as I went. This time, I had the alignment correct and there were no dust particles visible.
After using the card to remove the remaining air bubbles, I removed the protective plastic from the outside. I needed to work a couple of tiny bubbles from the corner which had been covered by the tab and not visible. After that, I had a clear, unscratched guard on my new Droid. I hope it will stay there and perform well. That is, of course, something that will only be evident with time. I still have one unused guard in reserve for when the installed one finally needs replacing.
Click Here to see more reviews about: Three LCD Screen Guards / Protectors for Motorola Droid A855
Click here for more information about Three LCD Screen Guards / Protectors for Motorola Droid A855
0 comments:
Post a Comment